Thickness: 2mil
VLT: 86%
IR REJECTION: 53%
VLR: 9%
UV REJECTION: 99%
TSER: 31%
Glare Reduction: 20%
SR Hardness: >2H
SURFACE RECOMMENDATION Car Sunroofs, Rear Windows, Building & Home Single- or Dual-Pane Glass, Bedroom Glasses.
Bathrooms, Smoth Glass, Single- or Dual-Pane Glass, Panels With Low-E Coatings, Plexiglas and Acrylic Windows, Wired, Textured, or Patterned Glass
HOW TO APPLY
1) Thoroughly clean the window the film will be applied to.
2) Cut your film to size of the window, adding an extra 2cm to the width and height.
3) Remove the clear lining film from back of the window film and spray the adhesive back of the film, as well as your fingers, with the soapy water solution. (Tip: If you cannot remove the clear lining film, attach a piece of sticky tape to either side of the film at one corner and peel away from each other.).
4) Spray the glass with the soapy water
5) Apply the adhesive side of the film onto the glass and slide into position
6) Spray the face of the film with the soapy water and, using a squeegee or credit card wrapped in paper towel, squeegee out all the soapy water from behind the film
7) Trim off any excess film using a sharp knife for a neat finish
